"INITIATE" command menu
"INITIATE" command menu |
Note | ||
When a system function is initiated with the ISAT, the MOTRONIC control module is made to do something that it would not otherwise do in the course of its normal operation. This may cause diagnostic trouble codes to be generated in other systems which are dependent on the MOTRONIC system. |
||
Initiation of a system function should only be done with the ignition switch in the Drive position and the engine idling. On activation with a gear selected, the ISAT display should show ENGINE IDLING. |
Important | ||
The activate functions should always be used with discretion. |
||
• |
Always deactivate an activated
function before proceeding further in
the ISAT menu.
|
• |
Always clear any fault codes generated in the MOTRONIC system, or in
any other system, when you are through with fault diagnosis.
|
No.
|
ISAT
display
|
Function
|
1
|
EVAP DUTY CYCLE
--.- %% + - |
Shows the EVAP canister purge valve's duty
cycle as a percentage. A
reading of 50%%is obtained on engagement, which can be adjusted in
steps of ± 0.4%%.
|
2
|
IDLING RPM
----RPM + - |
Shows idling speed in rpm. A reading of 1000 rpm is
obtained on
engagement, which can be adjusted in steps of ± 10 rpm.
|
3
|
IGNITION TIMING
--.- DEGREES + - |
Shows the ignition timing in degrees at idling speed.
A reading of
10.5 degrees is obtained on engagement, which can be adjusted in steps
of ± 0.75 degrees.
|
4
|
TURN OFF INJECTOR
1
|
Enables injector 1 to be turned off.
|
5
|
TURN OFF INJECTOR
2
|
Enables injector 2 to be turned off.
|
6
|
TURN OFF INJECTOR
3
|
Enables injector 3 to be turned off.
|
7
|
TURN OFF INJECTOR
4
|
Enables injector 4 to be tuned off.
|
8
|
TURN OFF INJECTOR
5
|
Enables injector 5 to be tuned off.
|
9
|
TURN OFF INJECTOR
6
|
Enables injector 6 to be tuned off.
|
10
|
IAC VALVE
-- %%CLOSED + - |
Shows the IAC valve's opening angle as a percentage. A
reading of
50%%is obtained on engagement, which can be adjusted in steps of ±
0.4%%.
|