ECM power supply
| ECM power supply |
| ECM power supply |
+30 voltage is supplied from maxi fuse 2 to the main relay, fuel pump relay and fuse 28. From fuse 28 voltage is supplied to ECM pins 1 and 48.
The ECM uses +30 for its memory. The engine does not start without +30.
+15 voltage is supplied from fuse 17 to ECM pin 60. When +15 is applied to pin 60, the ECM is activated, the main and fuel pump relays operate and all the injectors are activated for pre-injection dependent on engine temperature. The engine will not start without +15.
| Manual/Automatic programming |
The Saab Trionic ECM has the same part number for cars with manual and automatic transmission.
When pin 14 is energized through a position other than P or N being selected, the ECM is programmed for a car with automatic transmission.
On cars with manual transmission, the circuit to pin 14 is open.
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
