Hazard flashers
| Hazard flashers |
| 1. |
The direction indicators work,
but the hazard flashers do not.
Unplug the hazard flasher switch and connect a jumper lead between pins 1 and 4 of the connector. |
|
| 2. |
If the hazard flashers work, the fault is in the switch. Change the switch.
|
|
| 3. |
If this does not work, check the grounding of the switch by measuring the
resistance between pin 1 of the connector and a good grounding point. The resistance should
be < 1 ohm.
|
|
| 4. |
If the ground connection is OK, plug in a BOB and check the wiring for
continuity/shorting between pin 21 of the ICE module connector and pin 4 of the switch
connector.
|
|
| 5. |
Continue fault diagnosis as described on
.
|
|
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
