Checking the power supply
| Checking the power supply |
| 1. |
Ignition switch in the LOCK
position.
Connect a BOB and check the power supply for the Cruise Control system by measuring the voltage across pin F (6) of the control module connector and a good ground (e.g. a door hinge bolt). The voltage reading should be about 12 V. |
|
| 2. |
If the voltage is not 12 V, check the wiring harness for continuity or a
short circuit by measuring the resistance across pin F (6) of the control module connector and
the load side of the fuse.
The resistance should be > 1 ohm. |
|
| 3. |
It has not been possible to determine a fault using the above checks, proceed
with
.
|
|
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
