Input shaft speed sensor
Input shaft speed sensor |
To remove |
1. |
Turn the expansion tank aside.
|
2. |
Remove the sensor's screw.
|
3. |
Raise the car.
|
4. |
Remove the left-hand front wheel.
|
5. |
Inch out the sensor.
|
6. |
Unplug the electrical connector.
|
Fitting |
1. |
Plug in the sensor connector and fit the sensor in place.
|
2. |
Refit the front wheel.
Tightening torque 100 Nm (74 lbf ft) pressed steel wheels. 120 Nm (89 lbf ft) light alloy wheels. Lower the car to the floor. |
3. |
Tighten the sensor's screw.
Tightening torque: 6 Nm (4.5 lbf ft). |
4. |
Refit the expansion tank.
|