SAAB WIS ONLINE

P1785

Symptom: CHECK GEARBOX indicator lamp on. The system's emergency operation program has been activated.

P1785

Throttle position signal from fuel system, incorrect signal

Fault symptoms

CHECK GEARBOX indicator lamp on. The system's emergency operation program has been activated.

Conditions

Signal "throttle position missing or outside limits for longer period than 4 s".

Diagnostic help




The throttle position signal can be read with the diagnostic tool. Select "READ FUNCTIONS". Select "THROTTLE POSITION". Nominal value with released accelerator pedal is approx. 9%%. The value subsequently increases in proportion to the depression of the accelerator pedal to approx. 90%% when pedal is fully depressed.

The throttle position signal comes from a position sensor on the throttle via the Motronic 4.1 or Saab Trionic (4-cyl.) or Motronic 5.2 (6-cyl.) and provides information on the opening angle of the throttle. The signal is a 100 Hz PWM signal. The transmission control module uses it to control gear-shifting points and system pressure, among other things. A faulty throttle position sensor will cause a diagnostic trouble code to be generated in the engine management system and the CHECK ENGINE lamp (MIL) to light up.


Check the wiring

Intermittent faults may occur as a result of temporary short circuits and breaks in the wiring. Jiggle the leads at several places and in different directions to reveal any faults in the wiring harness, including connectors. Observe the multimeter, test lamp or ISAT scan tool while carrying out this check.

Diagnostic procedure

1 Check the DTCs in the engine management system



Check whether the CHECK ENGINE lamp (MIL) is on.

Is CHECK ENGINE on?

yes

Read and rectify the DTC in the engine management system if one is found, see Service Manual 2:7 "Engine Management System" for the respective systems. Then continue with step 4.


no

Continue with step 2.


2 Check the output signal from the engine management system





- Connect the BOB to the transmission control module connector but do not connect the control module.

- Start the engine.

- Take a reading across pins 25 and 35. The signal at idling speed: should be about 1.2 V 100 Hz 9%% (+) at 2500 ± 50 rpm: about 2.0 V 100 Hz 15%% (+).


Is the signal correct?

yes

Continue with point 4.


no

Continue with step 3.


3 Check the wiring


Take a resistance reading across pin 25 of the transmission control module and pin 54 of the Motronic 5.2 (6-cyl.), pin 52 of the Motronic 4.1 (4-cyl.) or pin 57 of the Saab Trionic. The resistance should be less than 1 ohm.

Is the resistance correct?

yes

Continue fault diagnosis as described in Service Manual 2:7 "Engine management system" and then continue with point 4.


no

Check and if necessary replace or repair the wiring or connectors and continue with point 4.


4 Final check


Clear the diagnostic trouble code, drive the car on test at varying engine loads and speeds for 5 minutes and obtain readouts of any diagnostic trouble codes that are generated.

Does the diagnostic trouble code recur?

yes

Continue with .


no

The remedial action taken was correct.