SAAB WIS ONLINE

Gear lever

Gear lever


To remove


1. Remove gear lever housing as described in Section "Gear lever housing".

2. Remove the locking plate holder.

3. Remove the spring that holds the locking plate.

4. Using a screwdriver snap out the rider which is governed from the ignition lock. Lift up the locking plate with its plastic fastener.

5. Remove the stop

6. Place the gear lever in reverse position and remove the screw that secures the gear rod to the gear lever.


7. Remove the gear lever with spherical socket by pressing in the three hooks


Fitting



1. Fit the spherical socket using a screwdriver.

Place gear lever with its spherical socket in the gear lever housing. The O-ring should be placed between the spherical socket and the housing.

2. Fit the screw which secures the gear rod to the gear lever. Turn the rod so that the hole for the locking pin faces upwards.

Tightening torque 20 Nm (15 lbf ft)

3. Fit the stop.

4. Insert the locking plate. Check that the locking plate's two bearings (rubber bushing and hat) in the housing are in place.

5. Clip the ignition lock's rider into the locking plate.

6. Fit the locking plate holder. The screws which secure the locking plate holder should be coated with thread locking fluid.

7. Fit the locking plate spring.

8. Adjust the position on the locking plate with the screw on the locking plate holder so that the locking plate is level with the heel in the gear lever housing.


Important

The stop may not touch the locking plate during the adjustment.


9. Fit the complete gear-lever housing and gear lever as described in the "Gear-lever housing" section.