Upper A pillar outer panel (conv.)
|
Upper A pillar outer panel (conv.)
|
1.
|
Mount the car in an alignment bench with measuring fixture and cross-measure as necessary.
|
2.
|
Roughly cut the top of the outer panel on the A pillar, 150 mm from the edge of the windscreen frame.
|
3.
|
Grind down the continuous weld securing the outer panel of the A pillar to the windscreen member.
|
4.
|
Cut the outer panel around the upper hinge.
|
5.
|
Drill out the spot welds securing the outer panel of the A pillar.
|
6.
|
Knock away the outer panel of the A pillar and align any deformed metal.
|
7.
|
Cut and position the new outer panel on the A pillar.
|
8.
|
Rub down the areas on the outer panel and body that are to be welded so they are clean.
|
9.
|
Apply welding primer to the surfaces to be plug and spot welded. Use Teroson Zinkspray.
|
10.
|
Put the outer panel in position on the body and fasten it with a few welding clamps.
|
11.
|
Fasten the A pillar outer panel to the reinforcement, securing it with plug welds and spot welds.
|
12.
|
All-weld the joint at the upper end of the A pillar and around the upper hinge.
|
13.
|
Grind the welds clean.
|
14.
|
Wash off surplus welding primer. Welding primer makes for poorer adhesion of paint, filler and sealant.
|
15.
|
Apply primer to all surfaces that have been ground clean. Use Standox 1K Füllprimer.
|
16.
|
Seal joints and metal folds with putty. Use Terostat 1K-PUR.
|
17.
|
Apply anti-corrosion agent to internal surfaces after painting. Use Terotex HV 400.
|