Control wire
Control wire |
To remove |
1. |
Remove the control panel. See
.
|
2. |
Remove the two clips holding the wire to the climate control unit and then remove the wire. V
|
To fit |
1. |
Refit the control wire at the rear of the control panel. The wire should be positioned above the control shaft.
|
2. |
Press on the clip securing the wire.
|
3. |
Refit the control panel.
|
4. |
Refit the wire on the lever of the air-blending flap.
|
5. |
Turn the heating knob to full cooling.
|
6. |
Hold the knob securely and at the same time push the control lever of the air-blending flap forward as far as possible.
|
7. |
Press into place the clip holding the wire sheathing to the climate control unit.
|
8. |
Check that the heater knob can be turned to both end positions without springing back.
|
9. |
Refit the panel on the centre console.
|