Recirculation motor
| Recirculation motor |
| To remove |
| 1. |
Remove the glove box. See Service Manual 8:2 "Interior equipment".
|
|
| 2. |
Unplug the connector.
|
|
| 3. |
Remove the recirculation motor from the climate control unit housing by unhooking the locking tongues.
|
|
| 4. |
Disconnect the motor shaft from the recirculation flap lever. If the shaft is in its bottom position, you will have to crack the link at the fracture notch with a screwdriver.
|
|
| 5. |
Lift out the recirculation motor.
|
|
| To fit |
| 1. |
Reconnect the shaft of the recirculation motor to the lever of the recirculation flap.
|
|
| 2. |
Press the motor into the climate control unit housing.
|
|
| 3. |
Plug in the connector.
|
|
| 4. |
Refit the glove compartment. See Service Manual 8:2 Interior equipment
.
|
|
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
