DTC detection
| DTC detection |
On obtaining readouts of diagnostic trouble codes with the ISAT from the ACC control module, the following procedure should be followed:
| 1. |
Clear any manual programming and then test drive the car on the road.
|
|
| 2. |
Obtain readouts of the diagnostic trouble codes and write them down on a piece of paper.
|
|
| 3. |
Carry out calibration.
|
|
| 4. |
Obtain readouts of the trouble codes again and make a note of any additional diagnostic trouble codes.
|
|
| 5. |
Take remedial action in regard to the trouble codes.
|
|
| 6. |
Carry out calibration.
|
|
This procedure should be followed, since diagnostic trouble codes B2403 and B2493 can only be detected in connection with calibration. Make a habit of carrying out calibration after doing any work on the ACC system. Calibration is done to enable the control module to set the end positions of the stepping motors. The end positions no longer apply if the +30 supply is interrupted.
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
