Rear doors
Rear doors |
To remove |
1. |
Open the front door to gain
access to the grommet for the rear door
wiring harness in the B pillar.
|
2. |
Withdraw the rubber sheathing for the wiring harness from the B
pillar.
|
3. |
Withdraw the connectors and unplug them.
|
4. |
Open the rear door.
|
5. |
Drive out the bush in the door keep.
|
6. |
Remove the hinge bolts.
|
7. |
Carefully lift the door off its hinges. It must be wide open to ensure
that it is not obstructed.
|
To fit |
Fit in reverse order. Hinge bolt tightening torque: 47 Nm (35 lbf ft)
Note | ||
To obtain a good fit between door and wing it might be necessary to lift the rear of the door slightly. |