SAAB WIS ONLINE

Replacement of door handle and lockcylinder, front doors, 5-D (3-D)

Replacement of door handle and lock cylinder, front doors, 5-D (3-D)


To remove

Door handle


1. Open the door.

2. Remove the door trim. See Service Manual 8:2 "Interior equipment" .

3. Remove the water barrier.

4. Detach the pull bar between the door handle and door lock from the door side and let it hang down.


5. Remove the guide channel's lower retaining screw and angle it out but do not undo the retainer at the top (plug-in retainer).

Note

3-D, pull the guide channel down slightly before angling it out.


6. Undo the clip securing the microswitch and unhook same.

7. Detach the pull bar (between the lock cylinder and lock) from the lock.

8. Remove the handle's locknut and plate from the rear of the handle.

9. Detach the push bar (between outside door handle and lock) from the lock.

10. It may be necessary to remove the lock (three screws).

11. Angle the handle out of the door.