SAAB WIS ONLINE

Front seat, excluding floor brackets

Front seat, excluding floor brackets

Important

In such cases you should use the method described on page 852-3.


To remove



1. Lower the seat as far as it will go.

2. 5-door: Detach the belt from the anchorage on the seat by pressing in the catch using a curved screwdriver

(see dimensional drawing).

3. Slide the seat forwards and remove the rear retaining bolts.


4. Slide the seat rearwards and remove the front retaining bolts.

5. Snip through the cable ties on the wiring and unplug the seat connector.

6. Lift out the seat.


To fit


Important

When fitting the seat it is important to tighten the retaining bolts in the right order. If this is not done, the seat will not work properly.



1. Lift the seat into position, guiding it onto the inner bracket's locating lugs.

2. Plug in the seat connector and fix the wiring by means of cable ties.

3. Fit the front retaining bolts. Tighten the inner bolt first.

Tightening torque: 30 Nm (22 lbf ft)

4. Slide the seat forwards and fit the rear bolts. Tighten the inner bolt first.

Tightening torque: 30 Nm (22 lbf ft)

5. Check that the seat locks properly into place on both sides simultaneously.

6. 5-door: Press the seat belt firmly down into the anchorage. Make sure that the catch engages properly.