Front seat backrest difficult to tip forward
SERVICE INFORMATION
|
Bulletin Nbr:
|
852-1878
|
Date:
...........
|
MARS 1998
|
Market:
|
ALL
|
|
Front seat backrest difficult to tip forward
|
Saab 900 3D M94-M98.
Saab 900 CV M95-M98
The cables in the release mechanism on cars with folding backrests may in time stretch slightly, this applies above all to the longer cable. This can result in the hooks used when tipping the backrest not opening sufficiently, making it difficult to tip the backrest.
By fitting a cable spacer between the two wires, the tension will be about the same.
Rectify after customer complaint.
49 03 431 Cable spacer (CA: 30576055)
The driver's seat has only one lever with a cable system, while the passenger seat has a lever on each side with separate cable systems. Make sure the passenger backrest can be tipped forward using
levers.
The following directions are for fitting a cable spacer to the outside of the passenger seat but also apply when fitting on the inside of the passenger seat and on the driver's seat.
1.
|
Remove the seat concerned from the car. See ”8. Seats, Adjustment/replacement, Front seats”
.
|
2.
|
Cut the clips securing the bottom of the backrest upholstery.
|
3.
|
Release the two upholstery rods holding the front of the upholstery taut by bending out the metal tabs.
|
4.
|
Fold and pull up the upholstery.
|
5.
|
Cut the three clips on the side of the seat where the cable spacer is to be fitted.
|
6.
|
Press in a cable spacer 49 03 431 between the two cables. It must be fitted at right angles to the cables.
|
7.
|
Make sure that
hooks are
engaged when the backrest is in its upright position.
Warning
|
If in the slightest doubt concerning the function:
|
•
|
Change the entire cable system.
|
•
|
Always make sure that
the locking function and the release function on the backrest are functioning correctly.
|
•
|
Do
fit the cable spacer if the cable system is replaced with a new one.
|
|
|
|
|
|
8.
|
Fit three new clips on the side on which the cable spacer was fitted. Use upholstery fitting kit 84 71 062.
|
9.
|
Hook on the two upholstery rods and secure with the metal tabs.
|
10.
|
Fix the lower edge of the upholstery by means of staples.
|
11.
|
Fit the seat in the car. See ”8. Seats, Adjustment/replacement, Front seats”
.
|
Warranty/Time information
|
Failed Object: 85216
Fault/Reason code: 27
Location code: 09
Warranty type (US): 01
Repair/Action code: 05
Labour Operation (US):85211
Time:0.4
(CA: C6010 LH/side 0.4 h, C6011 RH/side 0,4 h.)