Oxygen sensor
| Oxygen sensor |
| To remove |
| 1. |
Unplug the sensor cable
connector.
|
|
| 2. |
Note how the cable is run and the locations of any cable ties
before removing the cable.
|
|
| 3. |
Raise the car and remove the oxygen sensor.
|
|
| To fit |
| Important | ||
|
Before fitting, lubricate the threads on the oxygen sensor with Molycote 1000 or the equivalent. |
||
Fit in reverse order.
Tightening torque: 45 Nm (33 lbf ft)
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
