Crankshaft position sensor
|
|
Crankshaft position sensor
|
The crankshaft position sensor is located at the flywheel end of the
engine block, below the oil filter.
|
1.
|
Remove the engine
covers.
|
|
2.
|
Unplug the sensor's connector (by the left-hand side of the intake
manifold).
|
|
3.
|
Note how the wiring is run and the locations of the fastening points
for the cable ties. Then remove the wiring.
|
|
4.
|
Raise the car. Undo the sensor retaining bolt and remove the sensor.
Note how the sealing ring is positioned.
|
|
1.
|
Clean the sensor seating and fit
the sealing ring in the seating.
|
|
2.
|
Fit the sensor.
Tightening torque: 8 Nm (6 lbf ft)
|
|
3.
|
Refit the wiring and secure it with cable ties.
|
|
4.
|
Plug in the connector.
|
|
5.
|
Fit the engine covers back in place.
|
