Crankshaft position sensor
|
|
Crankshaft position sensor
|
The crankshaft position sensor is located at the flywheel end of the engine block
|
1.
|
Take off the engine
cover.
|
|
2.
|
Remove the turbo pressure rod and plug the turbo discharge
hose.
|
|
3.
|
Release the wiring from the sensor by unplugging the connector and removing
the clips/straps.
|
Important
|
|
Note the routing of the wiring.
|
|
|
|
|
4.
|
Disconnect the wiring.
|
|
5.
|
Remove the sensor's retaining screw and take out the sensor. Pay
attention to where the sealing ring is located.
|
|
1.
|
Clean the seating for the sensor
and fit the sensor with the sealing ring correctly positioned.
Tightening torque for retaining screw 8 Nm (5.9 lbf ft)
|
|
2.
|
Reset the wiring and secure it with clips/ straps.
|
|
3.
|
Join the connector together.
|
|
4.
|
Fit the turbo discharge pipe and the engine cover.
|
