Self-immobilization (3-circuit breaking)
|
Self-immobilization (3-circuit breaking)
|
The theft alarm can be programmed for self-immobilizing alone, and in this case,
only the alarm 3 circuit breaking is activated. This happens automatically without the use of
the remote control.
This function is only used when self-arming has been deselected. When self-arming is
selected, it is automatically included. Only two selections are possible and if the "ON" function
is selected, it will be connected according to the last selected alternative when self-arming. If
no self-arming alternative is selected, the function will be connected with the ignition off and
the door closed. When the function is active, this is indicated by the LED flashing 1
flash/sec. This happens after "TIME BEFORE ACTIV.".
Self-immobilizing
Connect the ISAT scan tool.
Select "PROGRAMMING"
Select "SELF-IMMOBILIZING" and then:
1.
|
"ON" to select self-immobilizing.
|
2.
|
"OFF" to deselect self-immobilizing.
|
Time before self-immobilizing
1.
|
Select "TIME BEFORE ACTIV."
if "ON" was selected above.
|
2.
|
Select time: 30, 60, 120, 180, 300 or 600 seconds as the time before the self-
immobilizing is armed.
|
Immobilizing time
Select "ACTIVATION TIME": 30, 45 or 60
minutes.