Gear selector position sensor, gear engaged
| Gear selector position sensor, gear engaged |
The gear selector position sensor is mounted in the transmission housing. It contains the reversing light switch, starting interlock switch and switches which inform the transmission control module on which gear is engaged.
The gear selector position sensor is basically a positional switch that is supplied with current via the +X circuit and in which a number of slip contacts indicate the selector position. Different combinations of the terminals A, B, C and PA indicate the selector lever position (see table). The slip contacts can be either closed (ON) or open (OFF).
Incorrect decoding of the slip contacts will cause limp-home to activate.
|
|
A
|
B
|
C
|
PA
|
|
P
|
ON
|
OFF
|
OFF
|
ON
|
|
R
|
ON
|
ON
|
OFF
|
OFF
|
|
N
|
OFF
|
ON
|
OFF
|
ON
|
|
D
|
OFF
|
ON
|
ON
|
OFF
|
|
3
|
ON
|
ON
|
ON
|
ON
|
|
2
|
ON
|
OFF
|
ON
|
OFF
|
|
1
|
OFF
|
OFF
|
ON
|
ON
|
The following table shows the relationship between the selector lever position sensor's internal terminals A, B, C and PA and the pins of connector H10-1 and those of the transmission control module.
|
Gear selector position sensor terminals
|
A
|
B
|
C
|
PA
|
|
Connector H10-1, pin
|
1
|
2
|
3
|
4
|
|
Transmission control module, pin
|
9
|
10
|
28
|
27
|
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
