Gear change mechanism
Gear change mechanism |
1. |
Remove the gear selector position sensor, see
.
|
2. |
Follow the instructions under "Dismantling the gearbox" in the section "Manual gearbox"
up to and including the point where the gear-changing mechanism is lifted out.
|
3. |
Place the gear change mechanism in a screw vice with protective jaw faces.
|
4. |
Tap out the clamping pin for the gear change lever's shaft.
|
5. |
Withdraw the spring pin for the gear selector position sensor's shaft.
|
6. |
Tap out the shaft and remove the selector lever.
|
7. |
Place the gear-changing lever with springs and sleeves in the bearing bracket. Press in the shaft with the elongated groove facing as shown. Drive in the spring pin.
|
8. |
Drive in the spring pin for the gear selector position sensor's shaft with the opening facing towards the spring pin for the gear-changing lever's shaft, as shown. It must not bottom but allow the gear-changing lever to move with ease.
|
9. |
Follow the instructions under "Assembling the gearbox" in "Manual gearbox"
from the point where the gear-changing mechanism is lifted in place.
|
10. |
Fit the gear selector position sensor in place, see
.
|