"ACTIVATE" command menu
"ACTIVATE" command menu |
Note
When a system function is activated with the Scan tool diagnostics instrument, the Sensonic control module will execute a command that is not functionally normal.
In activation mode the Scan tool diagnostics instrument controls the functions of the control module. For this reason the activation command should be used with discernment.
An activated function is always reset when you exit the activation mode and go further in the Scan tool diagnostics instrument menu, or when you exit the diagnostics mode. Always clear any diagnostic trouble codes that have been generated in the Sensonic or any other system when you have finished work during the activation phase.
Important | ||
Activation mode can be addressed only in gear position N. In other gear positions the Scan tool diagnostics instrument display will show CHANGE TO NEUTRAL AND THEN PRESS ON/ENTER. All activation commands can be cancelled with ESC. |
||
On completion of diagnosis, always clear all systems by using the CLEAR ALL command.
|
|
ACS LAMP
FUNCTION ON/OFF ON/OFF |
The control module is activated by the CHECK ACS warning lamp. In activation mode, CHECK ACS can be controlled by keys F1 and F2 of the Scan tool diagnostics instrument. F1 turns on the lamp (ON) and F2 turns it off (OFF).
|
ENGINE TURN-OFF
FUNCTION ON/OFF ON/OFF |
The engine can be switched off with this command. The F1 (ON) key of the Scan tool diagnostics instrument initiates engine turn-off. Safety function.
|
CRUISE CONTROL
FUNCTION ON/OFF ON/OFF |
The car's cruise control system can be disconnected with this command. The F1 key (ON) of the Scan tool diagnostics instrument turns off the cruise control and the F2 key (OFF) turns it on.
|
CLUTCH ACTUATOR
FUNCTION ON/OFF ON/OFF |
The control module can connect/disconnect the actuator. The F1 key (ON) of the Scan tool diagnostics instrument turns the actuator on and the F2 key (OFF) turns it off.
|
SID UNIT
NO MESSAGE OVERHEATED CLUTCH CHANGE DOWN DISENGAGE GEAR |
The SID unit should show the selected message. If "NO MESSAGE" is activated, the SID jumps out of diagnostics mode and shows the message previously displayed.
|