SAAB WIS ONLINE

Support arm

Support arm

To remove



1. Raise the car and remove the wheel.

2. Undo the anti-roll bar nut.

3. Undo the ball joint nut. Press out the ball joint, using special tool 89 96 696.

4. Undo the bolt securing the support arm to the suspension arm.

5. Unscrew the bolt securing the support arm to the subframe.

6. Remove the support arm, using an iron bar as a lever.


To fit



1. Fit the new support arm and tighten the bolt securing it to the subframe, using a torque wrench.

Tightening torque 100 Nm +75 ° to 90 ° (78.8 lbf ft + 75 ° to 90 ° )

2. Fit the bolt securing the support arm to the suspension arm and tighten it.

Tightening torque: 92 Nm (67.9 lbf ft).

3. Press the ball joint into the right position and fit the nut securing it.

Tightening torque: 75 Nm (55.4 lbf ft).

4. Tighten the anti-roll bar nut, using a torque wrench.

Tightening torque: 10 Nm (7.4 lbf ft).

5. Fit the wheel and tighten the wheel bolts, using a torque wrench.

Tightening torque: 105-130 Nm (77.5-95.9 lbf ft).

6. Lower the car to the floor.