Front wings
Front wings |
1. |
Unplug the connector for the side flashers.
|
2. |
Undo the screw securing the front of the wing to the inside of the wheel housing.
|
3. |
Lower the car to the floor.
|
4. |
Remove the wing liners from the front wing.
|
5. |
Remove the light cluster and unplug its connector.
|
6. |
Open the front door to gain access to the two rear wing retaining screws between the wing and the door.
|
7. |
Slacken the rear retaining screws.
|
8. |
Remove the seven retaining screws at the top of the wing.
|
9. |
Detach the bonnet gas spring from the structural member.
|
10. |
Carefully lift away the front wing.
|
11. |
Fit the bonnet gas spring to the structural member.
|
To fit |
Remove the rivets by pressing out the centre pin, using a drift.
1. |
Detach the bonnet gas spring from the structural member.
|
2. |
Lift the front wings into position.
|
3. |
Fit the bonnet gas spring to the structural member.
|
4. |
Loosely fit the retaining screws in the top and rear edge of the wing.
|
5. |
Adjust the position of the wing, aligning it with the bonnet and door.
|
6. |
Tighten the retaining screws.
|
7. |
Refit the door keep (if removed).
|
8. |
Fit the light cluster and plug in its connector.
|
9. |
Press the wing liner to the front wing, making sure it snaps in place.
|
10. |
Lower the car to the floor.
|
11. |
Fit the screw securing the front of the wing.
|
12. |
Plug in the connector for the side flasher.
|