Part of inner side panel, three-door body
|
Part of inner side panel, three-door body
|
1.
|
The side panel should already have been removed.
|
2.
|
Mount the car on an aligning bench and realign to the correct measurements if necessary.
|
3.
|
Cut the reinforcement in front of the wheel housing as shown.
|
4.
|
Drill out the spot welds that secure the cut section of the reinforcement in front of the wheel housing. Grind away the seam welds in the wheel housing.
|
5.
|
Cut the side panel at the B pillar as shown. Use the spare part as a template if the inner part of the B pillar is not to be replaced at the same time.
|
6.
|
Drill out the spot welds securing the inner side panel.
|
7.
|
Knock loose the inner side panel and realign any deformed metalwork.
|
8.
|
Use a grinder to clean the areas on the spare part and body that are to be welded.
|
9.
|
Apply welding primer to the surfaces which are to be spot welded. Use Teroson Zinkspray.
|
10.
|
Position the spare part and fix it with the three screws as illustrated.
|
11.
|
Fit the outer panel and tailgate in place and check the fit in relation to the door.
|
12.
|
Remove the side panel and tailgate.
|
13.
|
Spot weld the inner side panel in place.
|
15.
|
Roughly cut the reinforcement which is to be welded in place in front of the wheel housing.
|
16.
|
Fit the reinforcement in place and cut the spare part so that the joint can be butt-welded.
|
17.
|
Remove the reinforcement and drill holes for plug welding.
|
18.
|
Use a grinder to clean the areas on the reinforcement component and body that are to be welded.
|
19.
|
Apply welding primer to the surfaces which are to be plug welded.
|
20.
|
Position the reinforcement and fix it with a couple of welding clamps.
|
21.
|
Plug weld the reinforcement in place in front of the wheel housing and seam weld in the wheel housing.
|
23.
|
Grind the welds clean.
|
24.
|
Wash off surplus welding primer. Welding primer makes for poorer adhesion of paint, filler and sealant.
|
25.
|
Apply primer to all surfaces that have been ground clean. Use Standox 1K Füllprimer.
|
26.
|
Seal joints and metal folds with putty. Use Terostat 1K-PUR.
|