Thermostatic switch
Thermostatic switch |
To remove |
For cars with 6-cyl. engine go to step 3.
Note | ||
It is not necessary to empty the refrigerant from the system to carry out this measure. |
1. |
Drain the coolant and remove the lower radiator hose leading to the water pump (4-cyl.).
|
2. |
Undo the control valve if necessary (turbo).
|
3. |
Remove the cable tie and disconnect the thermostatic switch.
|
4. |
Cut off a 19 mm ring spanner to a length of approx. 120 mm.
|
5. |
Remove the thermostatic switch using the ring spanner.
|
To fit |
1. |
Transfer the plastic sleeve for the electrical connection to the new thermostatic switch.
|
2. |
Fit the new thermostatic switch.
|
3. |
Connect the leads and secure them with a cable tie.
|
4. |
Fit the control valve (turbo).
|
5. |
Fit the lower radiator hose leading to the water pump (4-cyl.).
|
6. |
Fill with coolant (4-cyl.) and bleed the system.
|
7. |
Perform a pressure test on the cooling system.
|