SAAB WIS ONLINE

Rear side trim

Rear side trim

To remove


1. Operate the soft top mechanism to the position illustrated.


2. Take out the cushion in the rear seat.

3. Remove the screw securing the front seat belt to the floor.

4. Detach the door seal from the side trim.

5. Remove the cover and screw securing the trim to the B-pillar.


6. Remove the plastic screws securing the bottom of the trim.

7. Fold forward the backrest.

8. Remove the screw and plastic screw securing the rear of the trim.

9. Carefully pull the trim upwards to detach it from the clip in the top rear corner. Hold the clip holder with one hand so that the trim is not damaged.


Important

Do not bend the trim. The trim or clip may be damaged.


10. Extract the seat belt from the side trim.

11. Unplug the connector to the lamp and lift away the side trim.


To fit



1. Plug in the connector to the lamp.

2. Insert the seat belt through the hole in the strap guide cover.

3. Put the trim in position and press on the clip in the top rear corner.

4. Tighten the screw and press on the plastic screws securing the rear of the side trim.


5. Raise the backrest.

6. Press on the plastic clip securing the bottom of the side trim.

7. Tighten the screw securing the trim to the B-pillar and then press on the cover.

8. Refit the door seal.


9. Make sure the seat belt has not become twisted and then tighten the screw securing it to the floor.

Tightening torque 45 Nm (33.3 lbf ft)

10. Put back the cushion in the rear seat.