25 SID does not sound a signal when the soft top is completely raised.
| 25 SID does not sound a signal when the soft top is completely raised. |
| A. |
Is SID correctly programmed?
Program SID for ’’soft top”. See “SID Information Display, Fault diagnosis, general, Programming”
|
|
| B. |
Does the fifth bow microswitch or the microswitches in the soft top cover lathes not close correctly?
The message ’’TOP CYCLE ERROR” may be displayed on the SID if one of the soft top cover microswitches is open when the other is closed. Read the microswitch readings with Tech 2. Adjust or replace if necessary. |
|
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
