SAAB WIS ONLINE

Floor console

Floor console

To remove



1. Apply the handbrake.

2. Remove the ignition switch cover plate by first loosening the front part of the left-hand side and then loosening the rear edge of the plate. Finally, unhook the front edge.

3. Unplug the connector for the ignition switch lighting.

4. Undo the floor console retaining screws.

5. Remove the rear ashtray/cover plate.

6. Remove the rear casing.

7. Remove the floor console retaining nuts.

8. Detach the floor console by pulling it straight to the rear and lifting it up slightly.

9. Remove the interior lighting switch by means of a screwdriver, pressing it up from underneath. Pull the switch straight up. It is secured by clips. Unplug the switch connector.


10. Remove the window lift module by loosening the front edge (snap fastener). Unplug the window lift module connector.

11. Lift out floor console.


To fit


Note

The centre console must be fitted before you fit the floor console.



1. Pass the floor console over the handbrake lever. Do not press the console into place but just let it rest loosely in position.

2. Pass the connector for the window lift module and interior lighting through the hole for the respective unit.

3. Plug in the window lift module connector and fit the module in place.

4. Plug in the interior lighting connector and refit the switch.

5. Tighten the floor console retaining screws and retaining nuts.


6. Fit the rear casing in place, making sure that the air duct connects properly to the air vent.

7. Screw the module firmly in place.

8. Refit the ashtray/cover plate.

9. Plug in the ignition switch lighting connector.

10. Refit the ignition switch cover plate.