Glass sunroof
Glass sunroof |
To remove |
1. |
Open the sunroof to expose the
screws securing the cover moulding.
|
2. |
Remove the four screws securing the cover moulding.
|
3. |
Close the sunroof.
|
4. |
Loosen the rear of the cover moulding by undoing the clips, one on each
side, and pulling towards the centre of the car.
|
5. |
Remove the cover strip over the screws on the left-hand and right-hand
sides. It is secured by clips.
|
6. |
Remove the six screws securing the glass sunroof.
|
7. |
Lift away the glass sunroof.
|
To fit |
1. |
Fit the sunroof in
position.
|
2. |
Fit the six retaining screws.
|
3. |
Adjust its alignment in the roof, one side at a time. 0 to 1 mm at the
front and 0 to + 1 mm at the rear.
|
4. |
Tighten the retaining screws.
|
5. |
Fit the two cover strips over the screws.
|
6. |
Open the sunroof slightly, allowing the cover moulding to be fitted in
place.
|
7. |
Fit the cover moulding in place, close the sunroof and press its clips
into position along the outer edge.
|
8. |
Open the sunroof slightly and tighten the four retaining screws.
|
9. |
Close the sunroof.
|
10. |
Check the operation of the bonnet-release
mechanism.
|