SAAB WIS ONLINE

Sunroof drive cable

Sunroof drive cable


To remove


1. Remove the sunroof assembly.

2. Remove the motor.

3. Remove the glass sunroof.

4. Remove the rain gutter.

5. Remove the locking ring and bend out the spring.

6. Remove the screw securing the cover at the rear, one cover strip on each side.


7. Move the rain gutter holders downwards towards the rear and withdraw them from the rail, one on each side.

Note

Holders with anti-vibration spring


8. Press down the catch at the rear of the slide mechanism and pull it rearwards.

9. Withdraw the cable to the rear.

10. Disconnect the cable from the slide mechanism, using a small screwdriver (snap-on fastener).


To fit



1. Attach the cable to the slide mechanism.

2. Insert the slide mechanism with cable until it snaps into place.

3. Fit the rain gutter holders.

4. Fit the anti-vibration spring and locking ring.

5. Apply a little adhesive to the rear edge of the covers.

6. Fit the rain gutter.

7. Adjust the cables on both sides. Check that the rivet is midway between the two marks on the link.


8. Fit the motor.

9. Fit the glass sunroof.

10. Fit the sunroof assembly.