Crankshaft position sensor
|
|
Crankshaft position sensor
|
The crankshaft position sensor is located at the flywheel end
of the engine block.
|
1.
|
Unplug the connector under the
intake manifold to release the
cable from the sensor. (The connector and cable under the
intake manifold are difficult to reach.)
|
Important
|
|
Note how the cable is run and the locations of the fastening
points for the cable ties.
|
|
|
|
|
2.
|
Snip through the cable ties and remove the cable.
|
|
3.
|
Undo the sensor retaining bolt and remove the sensor. Note
how the sealing ring is positioned.
|
|
1.
|
Clean the sensor seating and fit
the sensor with the sealing
ring correctly mounted.
Tightening torque, retaining bolt: 8 Nm (5.9 lbf ft).
|
|
2.
|
Refit the cable and secure it with cable ties.
|
|
3.
|
Plug in the connector.
|
