"ACTIVATE" command menu
| "ACTIVATE" command menu |
|
ISAT scan tool display
|
Function
|
|
INJECTORS
|
This command has a submenu, as follows:
• Injector, cyl. 1 • Injector CYL 2 • Injector, cyl. 3 • Injector, cyl. 4 Each injector is activated for 10 seconds at a frequency of 10 Hz. |
|
IGNITION COILS
|
This command has a submenu, as follows:
• IGNITION COIL CYL 1 • IGNITION COIL CYL 2 • IGNITION COIL CYL 3 • IGNITION COIL CYL 4 The relevant ignition coil is activated for 10 seconds at a frequency of 200 Hz. |
|
BOOST PRESS. VALVE
|
The boost pressure control valve (APC) is activated
for 10 seconds at a frequency of 90 Hz.
|
|
IAC VALVE
|
The idle air control valve is activated for 10 seconds
with a current of 0,6 A.
|
|
EVAP VALVE
|
The EVAP canister purge valve is activated for 10
seconds at a frequency of 8 Hz
|
|
PREHEAT OXY SENSOR FRONT
|
The oxygen sensor's heating circuit is
activated for 10 seconds.
|
|
PREHEAT OXY SENSOR REAR
|
The oxygen sensor's heating circuit is
activated for 10 seconds.
|
|
A/C RELAY
|
The A/C relay/compressor is activated for 10
seconds at a frequency of 1 Hz.
|
|
CHECK ENGINE LAMP
|
The CHECK ENGINE lamp (MIL) is activated for 10
seconds at a frequency of 1 Hz.
|
|
SHIFT UP LAMP
|
The SHIFT UP lamp is activated for 10 seconds at a
frequency of 1 Hz.
|
|
PUMP RELAY
|
The fuel pump relay is activated for 10 seconds at a
frequency of 1 Hz.
|
|
MAIN RELAY
|
The main relay is activated for 10 seconds at a
frequency of 1 Hz.
|
|
IDLING ADAPTATION
|
This command is used in connection with forced
adaptation of the throttle position at idling speed.
|
|
BOOST PRESS.RESET
|
This command is used in connection with resetting
boost pressure adaptation.
|
|
CANISTER CLOSE VAL
|
The shut-off valve for the EVAP system is activated for 10
seconds.
|
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
