SAAB WIS ONLINE

Wipe and wash

Wipe and wash


When the windscreen wiper stalk switch or the rear window wiper switch is set for washing, power is supplied to the headlamp wiper motor (not in the case of rear window washing), ICE module pins 38 (windscreen) and 15 (rear window), and also to the washer pump.

The ICE module grounds the two intermittent operation relays via pins 59 (windscreen) and 7 (rear window). The ICE module grounds the windscreen wiper relay directly and the wipers start at once. In regard to the rear window washer, however, the ICE module grounds the relay after a certain delay. This is because it takes a little longer for the washer fluid to spread out on the rear window.

Windscreen

At the end of the washing period, the ICE module grounds the relays for an additional 5 seconds. After a delay of 8 seconds the ICE module grounds the windscreen wiper relay for 0.5 second, causing the wipers to make an extra sweep of the windscreen. This extra sweep cycle can be programmed on/off with the scan tool, see .

Rear window

At the end of the washing period the ICE module waits for 16 seconds and then grounds the rear window wiper relay for 0.5 seconds to activate an extra sweep of the rear window wiper.