Programming for remote control, VSS
|
|
Programming for remote control, VSS
|
The remote control that is used for the car's anti-theft alarm must be programmed (coded) for that particular car. When the car is delivered, 2 pre-programmed remote control units are supplied. It is possible to have a total of 4 remote control units programmed for the car.
Remote control units
|
1.
|
Connect the ISAT scan tool.
Select "PROGRAMMING"
|
|
2.
|
Select "CONTROL".
Select "PROGRAMMING"
|
|
3.
|
Point the remote control at the aerial and press one of its buttons within 5 seconds of selecting the ISAT scan tool command. If between 1 and 3 additional remote control units are needed, program these in the same way as described here in point 3.
|
Important
|
|
All remote control units that are to be used must be programmed consecutively without leaving the ISAT scan tool programming mode for remote control units.
|
|
|
|
Check the number of programmed remote control units
Always check the number of remote control units that have been programmed.
- Ignition on (ignition switch in "ON" position).
- press the RH button on the remote control (tailgate).
- The LED flashes once for each programmed remote control.
Deprogramming all remote controls
|
1.
|
Select "CONTROL".
Select "DEPROGRAM ALL".
|
|
2.
|
All programmed remote controls are then deprogrammed.
|
Important
|
|
Unless 4 remote controls are used, none of them can be programmed unless all programmed remote controls have been deprogrammed as described in "Deprogramming all remote controls" above. Programming can then be carried out as described in "Remote controls" on the previous page.
|
|
Make a habit of always having the ignition in the drive position when deprogramming all remote controls. This is to avoid deprogramming while the car is armed.
|
|
If all remote controls are deprogrammed and the car is self-immobilized, it is still possible to program anti-theft alarm remote controls.
|
|
|
|
