Power supply +30
| Power supply +30 |
| Description of operation |
Positive voltage is supplied directly to the following components from battery 1:
| • |
Starter motor 4 and on to generator 2
|
|
| • |
Maxi fuse box 501
|
|
| - |
maxi fuses 1-5
|
Positive voltage is supplied from the battery via crimp J3 to:
| • |
Fuse board 342a
|
|
| - |
fuses 1-5 and 12
|
| - |
maxi fuses 1-4
|
| • |
Lighting relay 8
|
|
| • |
Dipswitch 8a
|
|
| • |
Crimp connector H6-7 and on to:
|
|
| - |
the relay coil, A/C compressor 156
|
| - |
the relay coil, secondary air injection pump 324
|
| - |
the relay coil, heater plates 553
|
| - |
the relay coil, secondary air injection control valve 584
|
| - |
ABS control module 547
|
| - |
fuse 19 in fuse board 22a
|
| • |
Theft alarm control module 289/583
|
|
The following components are supplied via maxi fuse 1 in maxi fuse box 501 and crimp J89:
| • |
Fuse board 22a
|
|
| - |
fuses 1, 4, 13, 23, 25, 33 and 34
|
The following components are supplied via Maxi fuse 2 in maxi fuse holder 501 and crimp J2:
| • |
Fuse board 22a
|
|
| - |
fuses 27 and 35
|
| • |
Starter relay 517
|
|
| • |
Light switch 10
|
|
| • |
Crimp J93 which in turn supplies
|
|
| - |
fuses 2, 12, 28 in fuse board 22a
|
| - |
relay contact in fuel pump relay 102
|
| - |
relay contact and coil in injector relay 229
|
| • |
Crimp connector H4-12, which in turns supplies
|
|
| - |
fuses 5, 10, 16 in fuse board 22a
|
The following components are supplied via maxi fuse 3 in maxi fuse box 501 and crimp J1:
| • |
Ignition switch 20
|
|
The following components are supplied via Maxi fuse 4 in maxi fuse box 501:
| • |
Relay contacts in ignition switch relay 21
|
|
The following components are supplied via Maxi fuse 5 in maxi fuse box 501:
| • |
TSAS control module 565
|
|
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
