13 Soft top does not stop low enough.
|
|
13 Soft top does not stop low enough.
|
|
A.
|
Has the bottom end position of the main motor been programmed incorrectly?
Reprogram the soft top. See
|
|
B.
|
Are the side rail screws loose?
Tighten the screws indicated on the illustration.
|
|
v
|
B.1.
|
Remove one screw at a time and apply threadlocker to the screw threads.
|
|
v
|
B.2.
|
Tighten the screws.
Tightening torque 23 Nm (17 lbf ft)
|
|
C.
|
Side rail resting on main motor - is the balance link bent?
|
|
v
|
C.1.
|
The linkage may be bent. Change the balance link.
|
|
v
|
C.2.
|
Carry out MI 811-1663 if it has not been done previously.
|
|
D.
|
Do the ’’B pillar” hinges hit the main motors when the soft top is lowered?
|
|
v
|
D.1.
|
Determine which side is causing the problem.
|
|
v
|
D.2.
|
Remove the three 13 mm nuts securing the soft top mechanism to the chassis.
|
|
v
|
D.3.
|
Lift up one side of the soft top unit slightly from the luggage compartment. Support it with a block of wood. Be careful of sharp edges and make sure not to damage the edge of the luggage compartment.
|
|
v
|
D.4.
|
Undo the four main motor retaining bolts and rotate the motor housing slightly forwards.
|
|
v
|
D.5.
|
Tighten the main motor.
|
