Checking SID (SAAB INFORMATION DISPLAY)
Symptom: No messages on the SID. ACC does not switch between “Soft top raised/Soft top lowered”
|
|
Checking SID (SAAB INFORMATION DISPLAY)
|
Fault symptoms
No messages on the SID. ACC does not switch between “Soft top raised/Soft top lowered”
Diagnostic help
This symptom arises if there is a fault in the communication between TSAS and SID. SID then generates diagnostic trouble codes B1476, B1478. The fault symptom also arises if SID is programmed incorrectly.
Diagnostic procedure
1 Check SID programming
|
-
|
Connect the diagnostic tool.
|
|
-
|
Turn the ignition switch to the ON position.
|
|
-
|
Read value “Data from TSAS” in SID.
|
|
-
|
Simulate a message by operating the ROOF button while the latches on the windscreen member are closed.
The diagnostic tool should display CHECK HEADER LATCHES
|
Does the diagnostic tool display the correct value?
Reprogram SID. Continue with step 3.
Continue with step 2.
2 Check the TSAS output
|
-
|
Connect test lamp 86 11 857 as follows
|
|
|
•
|
between pin 5 and pin 15 (B+)
|
|
-
|
Unlock the roof latches.
|
|
-
|
Turn the ignition switch to the ON position.
The test lamp should flash when the control module is awake.
|
Does the test lamp flash?
Change SID. Continue with step 3.
Check and if necessary rectify the lead between pin 5 on SID and pin 11 (K42) on TSAS. Continue with step 3.
3. Final check
|
-
|
Clear the diagnostic trouble codes.
|
|
-
|
Activate the soft top with the ROOF button and operate it for a few cycles
|
|
-
|
Make sure the soft top is functioning correctly and that no diagnostic trouble codes are generated.
|
Has the diagnostic trouble code recurred?
Change the control module as described in
The fault has been rectified.
