Adjusting the bonnet
| Adjusting the bonnet |
| Note | ||
|
The holes for the bonnet hinge mountings are elongated to permit adjustment of the bonnet position. |
| 1. |
Open the bonnet and slacken
the four bolts securing the hinges to the bonnet.
|
|
| 2. |
Adjust the bonnet and tighten the retaining bolts.
|
|
After adjustment:
| • |
Open and close the bonnet a few
times to check the operation of the locking and release mechanism. Drop the bonnet from a
height of about 30 cm (12 inches).
|
|
| • |
Pull the front of the closed bonnet upwards to check that the bonnet
lock has engaged properly.
|
|
| Adjusting the height of the bonnet |
| • |
Adjust the height of the bonnet by
means of the striker pin, nominal
height 62 mm. Adjust the stops accordingly.
|
|
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
