Backrest upholstery
| Backrest upholstery |
| To remove |
Centre armrest
| 1. |
Press out the sides of the backrest hatch at the sides of the armrest so that the spindles holding the armrest at the sides come free. Loosen one side at a time.
|
|
| 2. |
Place the armrest on a workbench.
|
|
| 3. |
Remove the upholstery. To do this, undo the fastening at the rear and pull the upholstery off the armrest.
Backrest |
|
| 4. |
Remove the entire backrest,
and
.
|
|
| 5. |
Place the backrest on a workbench, rear side facing upwards.
40%% section: Remove the locking clamp and pivot. 60%% section: Remove the pivot. |
|
| 6. |
Detach the upholstery with padding from the lower section. To do this, lift up the retaining strip all the way round and remove the upholstery with padding.
|
|
| 7. |
Loosen the upholstery by cutting through the staples.
|
|
| To fit |
| Note | ||
|
Fit in reverse order. Fasten the upholstery to the padding by means of staples using the tool supplied with assembly kit,
|
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
