Rear heated oxygen sensor (oxygen sensor2)
| Rear heated oxygen sensor (oxygen sensor 2) |
| To remove |
| 1. |
Take off the engine
cover.
|
|
| 2. |
Unplug the sensor wiring connector.
|
|
| 3. |
Before removing the wiring, note how it is run and the positions of any cable
ties.
|
|
| 4. |
Raise the car and remove the oxygen
sensor.
|
|
| To fit |
| Important | ||
|
Before fitting, lubricate the threads of the oxygen sensor with Molycote 1000 or the equivalent. |
||
Fit in reverse order.
Tightening torque 55 Nm (40 lbf ft)
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
