SAAB WIS ONLINE

Programming for remote control

Programming for remote control

The remote control that is used for the car theft alarm must be programmed (coded) for the particular car. When the car is delivered, 2 pre-programmed remote controls are included. It is also possible to program a further two remote controls (a total of 4 remote controls can be programmed) for the car.

PROGRAMMING

One remote control




1. Connect the ISAT scan tool.

Select "PROGRAMMING"

2. Select "CONTROL".

Select "PROGRAMMING"

3. Point the remote control at the antenna and press on of the buttons within 5 seconds of selecting the ISAT scan tool command.


Deprogramming a remote control




1. Select "CONTROL".

Select "DEPROGRAMMING".

2. Point the remote control at the antenna and press on of the buttons within 5 seconds of selecting the ISAT scan tool command.


Deprogramming all remote controls




1. Select "CONTROL".

Select "DEPROGRAM ALL".

2. All programmed remote controls are then deprogrammed.

Important

Make a habit of always having the ignition in the drive position when deprogramming all remote controls. This is to avoid deprogramming while the car is armed.

If a remote control is lost, all remote controls can be deprogrammed. This means that the customer must bring in all the remote controls for reprogramming.