"READ FUNCTIONS" command menu
|
"READ FUNCTIONS" command menu
|
|
Diagnostic tool display
|
Function
|
1
|
GEAR ENGAGED 1 2 3 3 + LOCK-UP 4 4 + LOCK-UP
|
Current selector lever position.
|
2
|
SELECTOR LEVER POS P R N D 3 2 1
|
The selector lever position sensor contacts, A, B, C and PA, inform the control module which gear has been selected. It is identified and presented.
|
3
|
OUTPUT RPM XX km/h
|
The output shaft speed signal comes from a sensor on the transmission. Transmission output shaft speed is the same as the speed of the car.
|
4
|
INPUT RPM XX rpm
|
The input shaft speed signal comes from a sensor on the transmission. The sensor measures the transmission input shaft speed after the torque converter.
|
5
|
SOLENOID PRESS REG XX mA X.XX bar
|
The pressure control solenoid controls the fluid pressure in the transmission. The control module controls the solenoid by means of a varying current. The command shows the current flowing through the solenoid and the converted fluid pressure.
|
6
|
THROTTLE POSITION XX%%
|
The transmission control module receives a PWM signal from the Motronic engine control module. The signal advises of the current throttle position (9-92%%).
|
7
|
TCS THROTTLE POS XX %%
|
The control module receives a PWM signal from the TCS control module. The signal states the current throttle position (9-92%%). This command applies only to the V6 engine.
|
8
|
OIL TEMP X.X V XX.X °C
|
The transmission is equipped with an NTC sensor, which measures the oil temperature. The command shows the NTC sensor's input signal to the control module (V) and the recalculated fluid temperature (°C)
|