SAAB WIS ONLINE

De-clutching bearing

De-clutching bearing


To remove

Remove the gearbox as described in Section 431 "Dismantling, assembly".


1. Remove the screw on the fork to the clutch bearing and pull out the clutch lever's shaft.

2. Remove the de-clutching bearing.


Fitting


1. Fit the de-clutching bearing together with the fork.

2. Fit the shaft.

3. Loosely fit the screw on the fork and turn the fork so that the play between bearing and clutch case disappears.

4. Tighten the screw on the fork.

Tightening torque: 25 ± 2 Nm (18.5 ± 1.5 lbf ft)

Important

The screw on the fork should be tightened with the clutch lever "fixed", i.e. press on the de-clutching bearing at the same time as the clutching lever is loaded.



Fit the gearbox as described in Section "Dismantling, assembly".