SAAB WIS ONLINE

State of rest

State of rest


If the control module processor is inactive for longer than three seconds it takes its state of rest, the control module turns off the processor. This is done to avoid EMI (Electro Magnetic Interference) in principally the radio reception. No self-diagnosis is performed in the state of rest. Any faults that occur will be detected when the processor becomes active again.

The processor leaves its state of rest in the following situations:


• When the ignition is turned to ON.

• When the "ROOF" switch is activated to operate the soft top.

• When any or all of the window lifts are operated with any of the five switches in the centre console.


The processor does not take its state of rest in the following situations:


• If the soft top, fifth bow or soft top cover are between two end positions.


When the processor is in its state of rest, it is not possible to establish communication between the control module and the diagnostic tool. To "wake up" the processor, one of the window lift switches can be operated, for example.