”ACTIVATE” commandmenu
| ”ACTIVATE” command menu |
Note
When a system function is activated with the Scan Tool, the Motronic control module is made to do something that it would not otherwise do in the course of its normal operation. This may cause diagnostic trouble codes to be generated in other systems which are dependent on the Motronic system.Activation should only be carried out with the ignition switch in the ON position.
The ISAT scan tool display texts below are presented in the same order as the commands under ACTIVATE in the ISAT scan tool menu structure.
|
|
|
|
INJECTOR 1
ACTIVE 30 s |
The injector is activated for 30 seconds at a
frequency of 1 Hz.
|
|
INJECTOR 2
ACTIVE 30 s |
The injector is activated for 30 seconds at a
frequency of 1 Hz.
|
|
INJECTOR 3
ACTIVE 30 s |
The injector is activated for 30 seconds at a
frequency of 1 Hz.
|
|
INJECTOR 4
ACTIVE 30 s |
The injector is activated for 30 seconds at a
frequency of 1 Hz.
|
|
EVAP VALVE
ACTIVE 30 s |
The purge valve is activated for 30 seconds at a
frequency of 0.5 Hz.
|
|
IAC VALVE
ACTIVE 30 s |
The idle air control valve is activated for 30 seconds,
with a 90%% and 10%% degree of opening for 1 second each.
|
|
AC RELAY
ACTIVE 30 s |
The A/C relay/compressor is activated for 30
seconds at a frequency of 0.5 Hz.
|
|
SECOND. AIR RELAY
ACTIVE 30 s |
The secondary air injection relay is activated for 30 seconds at a
frequency of 0.5 Hz.
|
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
