Checking the ICE data

/ 900 / 1998 / 3. Electrical system / Information Display (SID) / Fault diagnosis on the basis of fault symptoms / Checking the ICE data

1.	Connect a Scan Tool and select "READ VALUES" followed by "DATA FROM ICE".

2.	By proceeding as described below it is possible to simulate faults so that the ICE will send corresponding messages to the SID unit. Readouts of these messages can be obtained with the Scan Tool.

2.A.

Remove a rear parking light bulb and switch on the parking lights.

2.B.

Remove a brake light bulb and depress the brake pedal.

2.C.

Switch on the ignition. On depressing the brake pedal the signal should go away.

---

---

This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.