SAAB WIS ONLINE

Programming main instrument display panel 2

Programming main instrument display panel 2

It is possible to program main instrument display panel 2 by means of an ISAT Scan Tool. During programming, the Scan Tool does not show how the instrument is programmed and the procedure described cannot therefore be used to check this.

The main instrument display panel must be programmed in connection with replacement of the processor card or the complete unit.

Important

Before you start programming it is advisable to make a note of the odometer's unit of measurement (km or miles), engine version, tyre size and odometer reading. These details are needed for programming the main instrument display panel.


SCAN TOOL DISPLAY 1



MAIN INSTRUMENT UNIT 2

ADJUSTMENT

=>PROGRAMMING

READ SYSTEM INFO

1 Select PROGRAMMING in the Scan Tool's MAIN INSTRUMENT 2 menu.



SCAN TOOL DISPLAY 2



PROGRAMMING A NEW

MAIN INSTRUMENT

F1=CONTINUE

ESC=END

2 Proceed to the programming phase with F1 or end with ESC.



SCAN TOOL DISPLAY 3



SELECT TYPE OF

INSTRUMENT

KM INSTRUMENT

SELECT

3 State whether the instrument is to use km or miles as the unit of measurement.

Select using F3 or F4.



SCAN TOOL DISPLAY 4

SELECT TYPE OF

ENGINE XXXX

SELECT

4 State type of engine, may be B258 (V6), B206-234-204I (4-cyl) or B204L (turbo).

Select using F3 or F4.



ISAT SCAN TOOL DISPLAY 4a

SELECT TYPE OF TRANSMISSION

MANUAL/AUTOMATIC

4a If engine type B204L (turbo) was selected, 2 additional choices must be made in displays 4a and 4b.

State the type of gearbox.

Select using F3 or F4.



ISAT SCAN TOOL DISPLAY 4b

IS THE CAR WITH OR W/OUT HEAT SHIELDS

WITH/WITHOUT

4b If the car is of environmental class 1 type, it is equipped with heat plates.

Select using F3 or F4.



SCAN TOOL DISPLAY 5

SELECT CAR'S

TYRE SIZE XXXX

SELECT

5 State the car's tyre size, may be 185/65, 195/60 or 205/50.

Select using F3 or F4.



SCAN TOOL DISPLAY 6

ENTER CAR'S MILEAGE



XXXXXXXX KM/MILE

6 State odometer reading in previously selected unit of measurement. Be sure to state the correct reading. It is not possible to program a lower reading than that shown on the odometer.



SCAN TOOL DISPLAY 7

IS XXXXXXXX KM/MILE CORRECT

F1 = OK

ESC = END

7 Confirm the entered odometer reading.



ISAT DISPLAY 8

PROGRAMMING WILL NOW OCCUR

F1 = OK

ESC = END

8 Program instrument with input data.

This is your last chance to interrupt programming.



ISAT DISPLAY 9

PROGRAMMING CARRIED OUT

9 This menu confirms that programming has been carried out.



ISAT DISPLAY 10

PROGRAMMING INTERRUPTED

10 This menu is shown if programming was interrupted with ESC.