Programming for remote control
|
|
Programming for remote control
|
The remote control that is used for the car theft alarm must be programmed (coded) for the particular car. When the car is delivered, 2 pre-programmed remote controls are included. It is also possible to program a further two remote controls (a total of 4 remote controls can be programmed) for the car.
One remote control
|
1.
|
Connect the ISAT scan tool.
Select "PROGRAMMING"
|
|
2.
|
Select "CONTROL".
Select "PROGRAMMING"
|
|
3.
|
Point the remote control at the antenna and press on of the buttons within 5 seconds of selecting the ISAT scan tool command.
|
Deprogramming a remote control
|
1.
|
Select "CONTROL".
Select "DEPROGRAMMING".
|
|
2.
|
Point the remote control at the antenna and press on of the buttons within 5 seconds of selecting the ISAT scan tool command.
|
Deprogramming all remote controls
|
1.
|
Select "CONTROL".
Select "DEPROGRAM ALL".
|
|
2.
|
All programmed remote controls are then deprogrammed.
|
Important
|
|
Make a habit of always having the ignition in the drive position when deprogramming all remote controls. This is to avoid deprogramming while the car is armed.
|
|
If a remote control is lost, all remote controls can be deprogrammed. This means that the customer must bring in all the remote controls for reprogramming.
|
|
|
|
