Programming for siren

/ 900 / 1998 / 3. Electrical system / Theft protection / Adjustment and replacement / Programming for siren

In its basic version, only the special alarm horn is used to trigger the sound alarm. On certain markets, a siren with battery backup requires to be fitted. The alarm's horn is activated via a relay output in the control module. I.e. ground is connected to the horn when activated. The horn must be continuously supplied with +12 V and if this is absent, the siren will start. In order to achieve this, the alarm must be programmed for the siren. For correct operation, siren must also be selected from the "COUNTRY CODE" menu. See programming "COUNTRY CODE".

PROGRAMMING

Connect the scan tool. Select "PROGRAMMING". Select "SELF-ARMING" and then:

1.	"ON" if the siren is to be included.

2.	"OFF" if the siren is not to be included. Important IF "ON" is selected, the sound confirmation not available.

---

---

This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.